overview
EXO-COM (OPTIONAL) INSTALLATION
1. BEFORE INSTALLATION
Below parts are needed. Make sure you have them all.
EXO-COM Controller
Mic/Speaker
Battery Pack
Velcro paired with Fabric
(Circle shape 2 pcs, Ellipse
shape 2 pcs)
2. INSTALLING CIRCLE VELCRO
Circle Velcro may need to be attached to the speaker pockets first to fix the mic/speaker.
1) Remove the liner completely referring to previous page.
2) Find the speaker pockets on EPS, peel off the sticker paper on Velcro, and put one of each circle Velcro inside them.
Mic/Speaker
MIC/SPEAKER INSTALLATION
After the Velcro sits properly on the speaker pocket, peel off the sticker paper on the Fabric (that was paired to Velcro), and attach it to the back of mic/speaker.
Attach the mic/speaker to the Velcro. Make sure the mic is positioned at bottom, and mic hole is facing front (for best position to accept voices).
Put the mic/speaker cable on the back of bottom EPS referring to the above picture.
You can tidy it up by fixing it with Ellipse Velcro.
Make sure the male connector (3a) is properly positioned to be paired with female connector (3A) in the Controller.
NOTE: FOR SMART VERSION, MIC/SPEAKERS ARE PRE-INSTALLED. YOU CAN SKIP THE BELOW, AND JUST INSTALL THE CONTROLLER AND BATTERY PACK. YOU CAN PURCHASE EXO-COM SEPARATELY IF YOUR HELMET IS WITHOUT EXO-COM BUNDLED.
controller
EXO-COM CONTROLLER INSTALLATION
- Push up the Locking Lever (1) to remove EXO-COM Controller Cover (2), and put Mic/Speaker Female Connector (3A) into the hole first, and then Battery Pack Male Connector (3B) referring to the above picture.
- Install the EXO-COM Controller (4), and make sure it is properly positioned by sitting on two bumps (5) at the bottom.
- Connect the mic/speaker’s female connector (3A) to its male connector (3a).
- Reverse the process to remove the EXO-COM.
batterypack
BATTERY PACK INSTALLATION
- 1. Open up the liner in the back/bottom side of the helmet to reveal the battery slot between the EPS and the shell.
-
2. Plug the Battery Pack male connector (3B) to the Battery
Pack referring to the picture.
- 3. Put the Battery Pack back to the slot where the Battery Pack Cover is originally positioned.
- Make sure the EXO-COM Controller, the Battery Pack Assembly, Mic/Speaker and its wire are all properly set.
- Reverse the process if you want to remove the battery pack to charge or replace. It is easier if you push and lift up the battery pack lever when you remove it.
To find detailed information about using the EXO-COM Controller, refer to the EXO-COM Quick Start Guide, or User’s Manual.
NOTE: WHEN YOU RE-INSTALL THE LINER, CHECK IF ANY PART OF EXO-COM WIRE IS ON THE LINER SNAP HOLE. IT MAY CAUSE WIRE DISCONNECTION IF THE SNAP STRONGLY PUSHES THE WIRE.
WIRE STORAGE
- Put the wires into the pocket of the cheek pad. This helps you tidy up the cables.